Preparating your projector (continued)
Bottom side
Remote control
1 |
|
|
|
|
2 |
|
|
| 3 |
4 |
|
|
|
|
5 |
|
|
| 29 |
6 |
| 1 | 2 | |
|
| COMPUTER |
| |
7 | VIDEO | 28 | ||
|
|
| ||
8 | HOME | Page Up | AUTO POSITION | 27 |
|
| LASER | ||
9 | END | Page Down | 26 | |
|
|
| ||
|
|
|
| 25 |
10 |
|
|
| 24 |
11 |
|
|
| 23 |
|
|
|
| |
12 | MENU | ENTER | 22 | |
|
|
| ||
13 | ZOOM / FOCUS LENS SHIFT KEYSTONE | 21 | ||
VOLUME | ASPECT | |||
14 |
| EXPAND | PinP | 20 |
|
|
|
| 19 |
15 | CE | MUTE | STILL | 18 |
|
|
| ||
|
|
|
| 17 |
|
|
|
| 16 |
1
2
30
1Lamp cover
2Adjustment feet
Caution:
Do not replace the lamp immediately after using the projector because the lamp would be extremely hot and it may cause burns.
1Laser aperture
2Transmission window
3Wired remote control jack
4Indicator
5POWER button
6VIDEO button
7
8HOME button
9END button
10Mouse pointer
11LENS SHIFT button
12MENU button
13ZOOM/FOCUS button
14+ , - (VOLUME) buttons
15COLOR ENHANCER (CE) button
16MUTE button (Audio/Video)
17EXPAND button
18STILL button
19PinP button
20ASPECT button
21KEYSTONE button
22ENTER button
23
24Direction buttons
25LASER button
26AUTO POSITION button
27Page Up/Down buttons
28
29COMPUTER 1, 2 buttons
30Left click button
•The + and - buttons are used in the KEYSTONE adjustment and the EXPAND mode in addition to the volume con- trol.
•The direction buttons are also used for keystone and lens shift adjustments. The and buttons are also used for adjustment of the sub image display position in the PinP mode and zoom/focus adjustment.
•Pressing the LASER button emits a laser beam. Even when you keep holding down the LASER button, it is emitted only one minute. To keep emitting it longer, press the LASER button again.
•You can disable the LASER button to prevent laser radiation due to misuse of the button.
How to disable the LASER button
While holding the LASER button down, press the button 3 times.
How to enable the LASER button
While holding the LASER button down, press the button 3 times.
• Whenever the batteries are replaced, the LASER button is enabled.
About the laser beam
This remote control is a Class 2 laser product. (Max. output : 1 mW, Wavelength :
Beam Divergence : 6 m distance about 10.0 mm x 10.0 mm (±6.0 mm)
CAUTION :
•Pressing the LASER button on the remote control emits a laser beam. Do not look into the laser beam directly. Do not point the laser beam at anyone. Looking at the laser beam directly may damage eyesight.
•Use of controls or adjustments or procedures other than those specified herein may result in hazardous radiation exposure.
•This remote controller cannot be repaired.
