EN-44
Troubleshooting

The projector does not turn on.

No picture.

Image is unstable.

Image is blurred.

Cause Remedy
There is no power from the power
cable.
Plug the power cord into the AC inlet on the
projector, and plug the power cord into the
power outlet. If the power outlet has a switch,
make sure that it is switched on. See "Start
up" on page 22 for details.
Attempting to turn the projector on
again during the cooling process.
Wait until the cooling down process has
completed. See "Shutdown" on page 28 for
details.
Cause Remedy
The video source is not turned on or
connected correctly.
Turn the video source on and check that the
signal cable is connected correctly. See
"Basic Connection" on page 17 for details.
The projector is not correctly
connected to the input source device. Check the connection. See "Basic
Connection" on page 17 for details.
The input signal has not been
correctly selected.
Select the correct input signal with the
SOURCE button on the projector or remote
control. See "Switching input signal" on page
27 for details.
The lens cover is not open. Slide open the lens cover.
Cause Remedy
The connection cables are not
securely connected to the projector or
the signal source.
Correctly connect the cables to the
appropriate terminals. See "Basic
Connection" on page 17 for details.
Cause Remedy
The projection lens is not correctly
focused.
Adjust the focus of the lens using the focus
ring. See "Fine-tuning the image size and
clarity" on page 25 for details.
The projector and the screen are not
aligned properly.
Adjust the projection angle and direction as
well as the height of the unit if necessary. See
"Obtaining a preferred projected image size"
on page 13 for details.
The lens cover is not open. Slide open the lens cover.