Mitsumi electronic 6402 Wall Installation, Removing, Rotating, and Replacing the Handset Retainer

4.Snap one end of the coiled handset cord into the Handset jack (5 in

Figure 5). This jack is labeled . Thread the cord into the channel leading to the side edge of the voice terminal (4 in Figure 5).

5.Turn the telephone right side up, with the front facing you.

6.Snap the free end of the handset cord into the handset and place the handset in the cradle.

7.Snap the free end of the line cord into the modular wall jack.

8.Lift the handset and listen for dial tone. If there is no dial tone, check all wire connections to make sure they are secure.

Wall Installation

Note: For wall-mounting, you will need a 1-foot line cord. This cord is not supplied with the telephone, but can be ordered by using this comcode: 103786760.)

If you are wall-mounting the telephone, you should remove the tray from the base of the telephone. For this purpose, use the instructions listed under “Removing the Telephone Tray” later in this guide.

1.Make sure the 8-conductor wall mount plate is in place.

2.Do the following to reverse the handset hook. (The handset retainer is located under the handset as shown in a in Figure 6.)

—In order to release the handset retainer hook, press down on the hook and slide it toward the top of the telephone. (See b in Figure 6.)

—Rotate the hook 180 degrees (as in c in Figure 6) and then slide it back into its slot so the bottom part now sticks out from the top. (See d in Figure 6.) Snap the hook firmly into place.

a.b.

c.

¾

d.

FIGURE 6 Removing, Rotating, and Replacing the Handset Retainer

14