MK Sound Wiring the SS-150THX for THX Dipole Operation, Tripole or Dipole Operation

SS-150THX satellite speaker page 6

"INPUT" terminal labelled "1", and the Negative ( — ) lead from your amplifier or receiver should be connected to the BLACK ( — ) "INPUT" terminal labelled "2". See Figure 2 on Page 5.

TRIPOLE OR DIPOLE OPERATION

To operate in the Tripole mode, the jumper between the terminals labelled "3" and "4" must be in place. To operate the speaker in the THX Dipole mode, the jumper between the terminals labelled "3" and "4" must be removed. Do not throw away or lose this jumper. See Figures 3 and 4 on page 6.

VERY IMPORTANT:

The sensitivity of the speaker is slightly higher in the Tripole position. For critical listening, when switching from one mode to another, you should re-calibrate the level of the surround channels.

FIGURE 3

WIRING THE SS-150THX FOR THX (DIPOLE) OPERATION

(one channel only is shown for clarity)

Disconnect the Jumper between terminals 3 and 4

		SS-150THXTRIPOLE
Connect your	1	SURROUND SPEAKER
		DO NOT CONNECT YOUR
amplifier to	INPUT
		AMPLIFIER TO TWO RED
terminals	4 ohms	TERMINALS.
1 and 2.
	2	For remote control operation,
		see your owner’s manual.
FOR THX		MADE IN USA
(DIPOLE)
OPERATION:
remove jumper
between	3
terminals		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
3 and 4
		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
FOR TRIPOLE		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
OPERATION:		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
install jumper	4	MILLER & KREISEL
between
		SOUND CORPORATION
terminals
		10391 Jefferson Boulevard., Culver City, CA 90232
3 and 4
		Voice (310) 204-2854 Fax (310) 202-8782

_	+	_	+
LEFT SURROUND		RIGHT SURROUND

AMPLIFIER

FIGURE 4

WIRING THE SS-150THX FOR TRIPOLE OPERATION

(one channel only is shown for clarity)

Connect the Jumper between terminals 3 and 4

		SS-150THXTRIPOLE
Connect your	1	SURROUND SPEAKER
		DO NOT CONNECT YOUR
amplifier to	INPUT
		AMPLIFIER TO TWO RED
terminals	4 ohms	TERMINALS.
1 and 2.
	2	For remote control operation,
		see your owner’s manual.
FOR THX		MADE IN USA
(DIPOLE)
OPERATION:
remove jumper
between	3
terminals		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
3 and 4
		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
FOR TRIPOLE		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
OPERATION:		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
install jumper	4	MILLER & KREISEL
between
		SOUND CORPORATION
terminals
		10391 Jefferson Boulevard., Culver City, CA 90232
3 and 4
		Voice (310) 204-2854 Fax (310) 202-8782

_	+	_	+
LEFT SURROUND		RIGHT SURROUND

AMPLIFIER