SUGGESTED HOOKUP
| D600.2 | |
| SPEAKER | |
| OUTPUTS | |
+ - | + - | |
|
|
|
+ - | + - |
4 OHM | 4 OHM |
HOOKUP INTO TWO 4 OHM WOOFERS
| D600.2 |
| SPEAKER |
| OUTPUTS |
+ - | + - |
-+
4 OHM 4 OHM 
+-
HOOKUP INTO ONE DUAL VOICE COIL
(4 OHMS PER COIL) WOOFER
FEATURES
Ultra- Efficient Class D Audio Output Stage
Regulated
High Capacity Heat Sink
Adjustable 12db Low Pass Filter
Adjustable 45Hz Bass Boost
Low Level and Speaker Level Inputs
1% Surface Mount Components
Computer Optimized Transformer
Large Geometry Power MOSFETs
Overload and Thermal Protection
CONTROLS AND CONNECTORS
1.Positive Power Terminal - This is the power feed from the positive (+) terminal of the car’s battery. Use 8 gauge cable and good quality terminals when routing this connection. Tighten the connections well to prevent power loss due bad contact. Route the power cable away from the RCA and speaker cables
2.Fuses - Replace these fuses with only with the same type and value. These fuses only protect the amplifier. An additional inline fuse should be added at the battery to protect against a short in the main power cable to the amplifier.
3.Ground Terminal - For optimum performance, an 8 gauge cable and good quality connectors should attach the this terminal to the battery’s negative
4.Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12 volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.
