Moen Comprehensive Bidet Manual and Diverter Valve Installation Instructions

INSTALLATION INSTRUCTIONS

CAP

HANDLE SCREW

HANDLE

CARTRIDGE NUT

ESCUTCHEON NUT

ESCUTCHEON

Shroud

TRIM RING

DIVERTER VALVE

INSTALLATION OF DIVERTER TRIM

1.Remove cartridge nut and escutcheon nut from diverter valve.

2.Slide trim ring over diverter valve so that trim ring sets flat against bidet deck.

3.Place escutcheon over divertrer valve.

4.Install and lightly tighten escutcheon nut. Install and firmly tighten cartridge nut.

5.Place handle on diverter valve stem and secure with handle screw. Press cap into place on handle

INSTALLATION OF SHROUD ASSEMBLY

1.Apply 1/4” bead of plumber’s putty (not supplied) around lower flange of spray nozzle assembly. Hand tighten spray nozzle shroud onto spray nozzle assembly.

Pop up head piece

O-ring

Seat cover

Seat

INSTALLATION OF WASTE TRIM

1.Place seat cover into waste tube and push carefully down. Be careful not to bend seat cover.

2.Screw pop-up head piece firmly onto base part. Be careful not to cross thread the part. Ensure that o-ring is correctly seated on head piece.

Correct Disassembly Incorrect Disassembly

In order to remove seat cover, use screwdriver to bend snap features back from the inside as shown in picture. Do not try to lift seat cover with tool from outside.

Lift Rod Escutcheon

Rubber Gasket

Lift rod knob

Escutcheon Gasket

Steel washer Nut

Mounting Tube

Metal Washer

Mounting Nut

INSTALLATION OF LIFT ROD ASSEMBLY

Lift rod Lift and pivot assembly

Pivot rod

Waste assembly

1.Thread mounting tube into the lift rod escutcheon. Place the rubber washer below the lift rod escutcheon.

2.Insert the mounting tube through the bidet lift rod hole from above. Place the metal washer on the mounting tube. Thread the mounting nut onto the mounting tube and tighten.

3.Hook-up lift rod, and lift and pivot assembly to pivot rod as shown and tighen screws.

4.With drain plug in full open position, and the lift rod down, adjust the lift and pivot assembly for proper operation. Test lift rod action to make sure it operates freely. NOTE: If the lift rod or pivot rod binds against the “TEE” connection carefully bend the inlet and discharge tubes slightly outward to clear lift rod.

2