MT302E
MODEL 72964 Series
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
TWO HANDLE
TUB & SHOWER VALVE
Measurements
These are shown on the drawings. The depth measurment is critical. The center line of the supply and discharge piping should be a maximum of 3-1/16” (78mm) and a minimum of 2” (51mm) behind the finished wall surface, including tile. This is 1-1/16” (27mm) of adjustment.
Pipe, ells and nipples are not furnished with the valve.
SPOUT
CAUTION: | Always turn water off before disassembling the valve. Open both valve handles to |
relieve water pressure and to insure that COMPLETE water shut-off has been accomplished. |
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer nuts are in place. The cartridges and retainer nuts were probably installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer nuts may not be properly installed. This should be care- fully checked at time of rough-in and trim-out. If the retainer nuts are not properly installed, water pressure could force the cartridges out of the casting. Personal injury or water damage to the premises could result.