Specification
Low frequency limit:- | 27Hz (EQ1) 21Hz (EQ2) |
Upper frequency limit:- | 40 – 120 Hz Variable |
Low pass filter alignment:- | Active 4th order 24db/octave |
Cabinet Specification: - | Sealed Cabinet of 25mm M.D.F construction with internal |
| bracing |
Amplifier Output:- | 500 Watts (RMS) 1000 Watts (Peak) |
Amplifier classification:- | Class- D Digital amplifier |
Driver compliment:- | 1 x 12” |
| and 3” long throw voice coil |
Dimensions:- | Cabinet: 340 x 340 x 380mm |
(H x W x D) | 13 3/8 x 13 3/8 x 14 15/16 Inches |
| Inc Amp and Driver: 340 x 340 x 410mm |
| 13 3/8 x 13 3/8 x 16 1/8 Inches |
Weight (unpacked):- |
|
Input Impedance: - | 20K Ohms |
Mains input voltage:- | 110 - 120 Vac / 220 - 240 Vac 50/60Hz |
| (Electronically Auto selected) |
10 | Silver |
RXW12 manual.indd
Trouble Shooting
Should you experience any technical, or
My subwoofer will not turn on/no power.
•Is the LED illuminated on the back of the unit? If not, then check your mains lead is properly connected both at the subwoofer and at the mains outlet. Also check the fuse of the mains plug (where fitted) and also the fuse in the subwoofer. See page 6 & 8 for further information on changing the fuse and it’s location.
•Is the LED on the back red? If so, you have power going to the unit. It could be that there is no signal, or the 12v trigger is connected and the source not turned on (see below).
•Have you got the 12v trigger connected? If so, the subwoofer will not power up until the source is powered up.
•Has it got a signal going to it (12v trigger not being used)? If so, is the Power Mode Switch in the Auto or On position, and the signal source is turned on? Try adjusting the volume level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio immediately.
No sound from subwoofer.
•Is the LED on the back red or green? If it is red, then the unit hasn’t actually turned on.
See above suggestions. If it is green, then your unit is powered up and turned on. Check further suggestions below.
•Are the signal leads connected correctly? Check these. If possible, check with a second, known to be working set.
•Is the volume level just very low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio immediately.
monitoraudio.co.uk | 11 |
18/08/2009 10:04:08
