19
Remove 2 screws in yoke (see insert). Remove 3 screws with key- hole slots from top of fan.
22 | Hands free hook |
Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #10.
25
Install blades and blade plates to motor using the 9 motor screws pro- vided. Tighten screws securely.
28
Connect plug from fan to switch house plug.
| 20 |
| Center | Canopy |
|
| |||
|
|
| ||
|
|
| Hole | Larger |
|
|
|
| holes |
| Smaller |
| ||
| holes |
| ||
Place canopy on top of the fan motor allowing the yoke, wires and safety cable to pass through the large hole in the center of the canopy. Align the 3 larger holes around the center hole with the 3 screws still installed in the fan. Install 3 screws removed into small holes in canopy to make it a flush mount canopy and tighten screws securely.
23
Lift fan to mounting bracket, aligning the “L” shape holes with the scresws on the mount- ing bracket. Turn the fan clockwise to lock in position. Install the other two screws and tighten securely.
26
Loosen 2 screws with key slots and remove 1 screw without slot from motor plate and save screw.
29
Remove 3 screws and save to install switch housing.
21
Install two screws corresponding with the “L” shaped holes in the canopy only part way so that canopy can twist into place.
Remove the all thread studs from the lower part of the mounting bracket.
24
Blade plate
Align the blade and then the blade plate with castings on motor to attach blades to motor.
27
Install switch housing plate by twist- ing plate with key hole slots into place. Replace screw removed and tighten the 3 screws securely.
30
Install the switch housing using the 3 screws previously removed.
