19
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
22
Place floating brackets onto blades aligning holes in blade with the floating bracket.
25
Loosen the 2 screws with key slots and remove the screw without key slot. Pass plug and capacitor through hole in plate. Take plate and place over the 2 screws with key slots and twist to hold in place.
28
After attaching blades; install the switch hous- ing with the three screws previously removed.
20
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
23
Place blade arms onto the other side of the blade and aligning holes. Insert screws with fabric washers through the holes and tighten securely.
26
Capacitor
Tighten the three screws securely holding the plate for the switch housing. Remove the dou- ble sided tape from capacitor and stick capaci- tor to plate.
29
Remove cover by snaping off from top or bottom. Install 12V battery into wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.
| 21 |
|
|
|
|
|
| AC 120 V |
| input | |||
|
|
| black |
| white |
|
|
|
|
|
| ||
white
black
green ground
green ground
Make wiring connections as shown black wire from house to black wire from fan. White wire from house to white wire from fan. Connect all green ground wires to ground wire from house. Refer to diagram above.
24
Check the motor for plastic shipping stabilizer tabs, and remove them if they are present. Attach blade assembly to motor by tighten screws securely.
27
Make sure to connect the plug from remote to the plug coming from fan body according to the arrows indicated on the plugs, otherwise the remote will be damaged.
30
Attach cover of remote by placing over buttons and snaping into place.
