19
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
22
Place light kit over screws and twist into place. Then tighten all 3 screws securely.
25
Install the 3 x 40 watt incandescent candelabra bulbs.
28
Place light kit cover over frame with the glass aligning the 3 holes. Install and secure the 3 screws.
20
Raise canopy to the mounting bracket and twist to lock into place. Tighten 2 screws securely.
23
Plug white wire from fan to white wire from light kit. Then plug black wire from fan to black wire from light kit.
26
Loosen 3 set screws. Place glass into frame and tighten 3 set screws securely.
29
Raise glass with the frame up to the light kit socket assembly aligning 3 pertruding nipples. Twist counter clockwise to lock into place. Be sure that the glass and frame goes all the way up to the motor.
21
Loosen 2 screws and remove 1 screw. Save screw removed.
24
Place heat shield over screws and twist into place. Then tighten all 3 screws securely.
27
Remove 3 screws from the frame with the glass. Save these screws.
30
Reverse function for this fan is a switch on top housing of the fan body. Turn fan off and flip switch, this will reverse the direction of the blades.
