Morphy Richards 28022, 28009 operating instructions Location of controls, Electrical requirements

2 Band Alarm

Clock Radio

28009 / 28022 OPERATING INSTRUCTIONS

Illustration

1 4	1 3	1 2	1 1
			1 0
1 5
1			9
			8
2			7
3
			6
4			5

Location of controls

1	Function selector switch	9	Hour button
2	PM indicator	10	FM wire aerial
3	Alarm indicator	11	Time button
4	Dial scale and pointer	12	Sleep button
5	Tuning control	13	Alarm button
6	Band selector switch AM/FM	14	Snooze button
7	Buzzer/Volume control	15	Battery compartment
8	Minute button		(located underneath unit)

P.2

Electrical requirements

Check that the voltage on the rating plate of your clock radio corresponds with your house electricity supply which must be A.C. (Alternating current).

For clock radios with fitted plug.

If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted.

IMP0RTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED, MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET.

Should the fuse in the 13 amp mains plug require changing a 3 amp BS1362 fuse must be fitted.

The socket outlet should be installed near the equipment and shall be easily accessible.

Battery back-up facility (unit will work without a battery being fitted) Your alarm clock radio is equipped with a battery back-up facility.

1Remove the battery compartment cover (located underneath the unit) by pushing in the clip and lifting off.

2Insert a battery size 9 volts PP3/6LR61 and connect to terminals (Ensure batteries are inserted correctly)

3Replace the battery compartment cover.

Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate. The display will be extinguished to conserve battery life but the memory will retain details of the clock time and alarm settings.

If the optional battery is not installed in case of the AC power failure the display will blink to indicate the power was interrupted. You will need to reset the clock and alarm.

Battery back-up is designed to operate for a short period only.

If the unit is not to be used for a prolonged period, remove the battery to avoid battery leakage.

In the interests of environmental safety : dispose of batteries safely.

Switching on and setting the clock time

Before any alarm functions can be used, you must set the clock to the correct time.

1Place the unit on a flat surface. Plug the mains plug into the wall socket and switch on the wall socket

2The LED clock display will flash.

3Press and hold the TIME button (11) and simultaneously hold down the HOUR button (9) or the MINUTE button (8). The LED clock display will fast forward the minutes and hour segments. Release the TIME button (11) when your desired time is set.

4The PM indicator (2) will illuminate to indicate 12.00 midday has been reached.

Radio operation

FM wire aerial

To obtain the maximum FM reception fully extend the wire FM aerial (10) (which is located at the rear of the unit) and alter the direction of the wire for best results.

The aerial for the AM waveband is located inside the unit. To obtain the maximum AM reception rotate the clock radio.

1Slide the FUNCTION SELECTOR switch (1) to the ‘ON’ position.

2Adjust the VOLUME control (7) to a suitable level.

3Set the BAND SELECTOR switch (6) to either AM or FM as desired.

4Slowly adjust the TUNING control (5) to select your desired station.

5To switch off the radio, slide the FUNCTION SELECTOR switch (1) to the ‘OFF’ position.

P.3 P.4