2 Band Alarm
Clock Radio
28043 OPERATING INSTRUCTIONS
Electrical requirements
Check the voltage on the rating plate of your clock radio corresponds with your house electricity supply which must be A.C. (Alternating current).
For clock radios with a fitted plug.
If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted.
IMPORTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED, MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require changing a 3 amp BS1362 fuse must be fitted.
Battery
Your alarm clock radio is equipped with a battery
1Remove the battery compartment cover (located underneath the unit) by pushing in the clip and lifting off.
2Insert a battery size 9 volts PP3/6LR61 (Ensure batteries are inserted correctly)
3Replace the battery compartment cover.
Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate. The display will be extinguished to conserve battery life but the memory will retain details of the clock time and alarm settings.
If the optional battery is not installed in case of the AC power failure the display will blink to indicate the power was interrupted. You will need to reset the clock and alarm.
Battery
If the unit is not to be used for a prolonged period, remove the battery to avoid battery leakage.
In the interests of environmental safety : dispose of batteries safely.
Illustration
14 | 1 | 2 | 3 | 4 | 5 | 6 |
| 13 |
| 7 |
| 12 |
| 8 |
|
|
| |
|
|
| 9 |
| 11 | 10 |
|
Location of controls |
|
| |
1 | Minute button | 8 | Band switch |
2 | Hour button | 9 | Tuning control |
3 | Alarm set/off | 10 | LED clock display |
4 | Time set button | 11 | Dial scale with pointer |
5 | Sleep button | 12 | Alarm indicator |
6 | Snooze button | 13 | PM indicator |
7 | Volume control / buzzer | 14 | On/off/auto switch |
P.2
Switching on, and setting the clock time
Before any alarm functions can be used on your alarm clock radio you must first set the clock to the correct time.
1Place the unit on a flat surface. Plug the mains plug into the wall socket and switch on the wall socket.
2The clock LED display (10) will flash.
3Press and hold the TIME button (4) and simultaneously hold down the hour button (2) or the minute button (1). The LED clock display (10) will fast forward the minutes and hour segments. Release all buttons when the correct time is set.
4The PM indicator (13) will illuminate to indicate 12.00 midday has been reached.
Radio operation
FM wire aerial
To obtain the maximum FM reception fully extend the wire FM aerial (which is located at the rear of the unit) and alter the direction of the wire for best results.
The aerial for the MW waveband is located inside the unit. To obtain the maximum MW reception rotate the clock radio.
1Slide the ON/OFF/AUTO switch (14) to the ‘ON’ position.
2Adjust the VOLUME control (7) to a suitable level.
3Set the BAND switch (8) to either MW or FM as desired.
4Slowly adjust the TUNING control (9) to select your desired station.
5To switch off the radio, slide the ON/OFF/AUTO switch (14) to the ‘OFF’ position.
P.3 | P.4 |
