
40310 Rev 2 24/8/07 15:08 Page 6
Vertical steam (certain models only) Hold the iron in a vertical position
between 1cm and 2cm away from the item D. Press the shot of steam button ‹, this will create vertical steam. This feature is especially useful for removing creases from
hanging clothes, | D |
curtains, wall hangings | |
etc. |
|
Note: For optimum |
|
steam quality, do not |
|
operate the shot more |
|
than three times in |
|
succession. |
|
Emptying and storing
When you have finished ironing, unplug
your iron. Ensure that
the steam control is set
at the ‘ ’ position, lift up the fill cap and empty any remaining water out of the filling hole.
Do not store in the box, but in an upright position, so that any drops of water remaining cannot leak out and discolour the soleplate.
Important: The flex can be damaged if wound too tightly around the iron after use. Make a loose loop with the
flex and wrap it around the iron. The iron must be cool before winding the flex and storing on its heel.
Maintenance
Jet cleaning (certain models only)
Your iron has a built in cleaning system designed to keep the water valve, steam chamber and steam vents clear of lint and loose mineral deposits. The ‘jet clean’ should be operated after each period of ironing.
To operate, ensure that there is little
water in the tank, place the iron on its heel and turn the temperature control dial to the maximum setting. Wait for the temperature indicator light to go out, then unplug the iron and hold it about 6’’ (150mm) above the sink in the ironing position. Press the shot of steam button about 10 times in succession.
After this cleaning operation, empty out any remaining water.
To clean an aluminium soleplate
To keep the soleplate of your iron clean and free of limescale, make a paste of mild scouring powder and a little water. Apply a small amount to the soleplate, rub and then remove with a damp cloth. Wipe thoroughly with a clean cloth.
To clean a stainless steel soleplate (certain models only)
To keep the soleplate of your iron clean and free of limescale, we recommend that you use one of the gentle chrome, silver or stainless steel cleaners that are generally available. Always follow the manufacturers instructions. To clean off melted
To clean the exterior
Allow the iron to cool and wipe over with a damp cloth and mild detergent, then wipe with a dry cloth.
6