Morphy Richards 40725 manual Filling a, Temperature Control B, Features of Your Iron

40725 rev4 28/8/07 15:32 Page 5

A

B

C

FILLING A

1Make sure that the iron is not plugged in, then set the steam

to dry iron selector switch ⁄ to the position before filling the iron with water.

2Lift up the filler cap and fill the tank ‡ with water through the filling hole ‰, using the beaker provided (300ml). A Â After filling replace the filler cap. In hard water areas the use of distilled or demineralised water is recommended.

WARNING: Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refrigerator.

3Always pour out the remaining water after use.

WARNING: When filling your iron with tap water always use the beaker provided. Never fill directly under the tap.

TEMPERATURE

CONTROL B

Plug in the iron and switch on. Set the temperature control dial

¤to the temperature required, but don’t start ironing immediately.

If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light fl which will go on and off while you are ironing.

This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen.

It is always a good idea to begin with cool fabrics and work up to higher settings.

An iron heats up quicker than it cools down so you’ll save time and electricity.

1

2

FEATURES OF YOUR IRON

Temperature indicator light

The indicator light fl shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation.

Dry ironing

You can use your iron as a dry iron only. Make sure the steam to dry iron selector switch ⁄ is

set to the symbol.

Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only.

Spray C

Press the spray button › and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed.

Automatic variable steam B

Fill the iron with water as described in the filling section, and insert the plug into the electrical socket.

Set the ‘steam to dry iron’ selector switch to steam ⁄.

Select the temperature required by turning the temperature control dial ¤ to the desired setting. The amount of steam required is automatically selected and is displayed in window ‹.

www.morphyrichards.com 5