Morphy Richards 73276 Tube standby G, Switching off H, STORAGE Tube park, Filters, G H I J K L M

Models: 73276

1 8
Download 8 pages 45.2 Kb
Page 6
Image 6
G

73276 rev1 30/9/08 13:22 Page 6

G

H

I

J

K

L

M

Tube standby G

During short breaks in cleaning, the tubes can be held in an upright, ‘standby’ position ä, whilst you move furniture for instance.

IMPORTANT: Ensure that the appliance is never left unattended whilst it is switched on.

Switching off H

Switch off the appliance. Remove the plug from the mains supply and rewind the power cable using the cable rewind switch á.

WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly.

STORAGE

Tube park I

The vacuum cleaner can be stored in an upright position. Rotate the floor nozzle until the lug on the neck can be fitted into the tube park slot æ on the base of the appliance.

MAINTENANCE

DUSTBAG

Changing the dustbag

If suction power is reduced or if the ‘dustbag full’ indicator à is permanently fully red, the dustbag needs changing. Also, check whether the suction hose, tube or nozzle are blocked.

To access the dustbag, press the dust compartment release lever Û to open the cover J.

1Pull the tab on the dustbag to one side so that the opening is hygienically sealed.

2Pull out the dustbag holder é and dustbag in an upward direction K.

3Pull the bag è sideways out of the holder é L.

4Dispose of the bag with your household waste.

5Insert a new dustbag in the holder.

6Replace the dustbag holder and close the cover.

IMPORTANT: If a dustbag is not fitted, the cover will not close. This is a safety feature.

FILTERS

Changing/cleaning the motor protection filter

The motor protection filter is accessible from the dust compartment only when the dustbag has been removed first.

IMPORTANT: Never use the appliance without the motor protection filter installed, otherwise damage to the motor may occur which would not be covered by the guarantee.

1Slide the filter cover Ü upwards to remove M.

2Take out the filter and clean (by shaking) or wash M.

3To wash the filter, gently wash in warm water and leave to air dry. Do not use detergents. Ensure the filter is fully dry before replacing into the machine.

4Slide the filter holder back into position.

IMPORTANT: Check this filter every time the dustbag is replaced and clean if necessary.

 

 

6

UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119

Page 6
Image 6
Morphy Richards 73276 manual Tube standby G, Switching off H, STORAGE Tube park, MAINTENANCE DUSTBAG Changing the dustbag