Morphy Richards 73380 Assembly, OPERATING THE APPLIANCE Using on carpets, Using on hard floors

73380 rev4 15/2/08 09:23 Page 4

A

B

á

C

Ü Û

ä

D

è

é

E

Assembly

WARNING: Do not plug in the cleaner until it is assembled.

1Carefully unpack all components.

2Lift cleaner body to upright position.

3Insert the handle into the hole on the top of the product. Push down until it clicks.

NOTE: The handle may be removed by lifting while simultaneously pushing the release button with a suitable tool eg. a small screwdriver A. The release button is located in a hole at the rear of the product just above the cable cleat. Rotate the cable cleat downwards for easier access.

OPERATING THE

APPLIANCE

Using on carpets

1Place cleaner in its upright position.

2Release the mains cable by turning the quick release cleat ç half a turn and extend the cable fully.

3Plug the mains cable into the mains socket.

4Clip the cable into the cable clip holder ñ at the rear of the handle.

5Place your foot on the foot pad á on the floorhead whilst pulling the handle towards you to release the handle into the cleaning position B.

6Press the power on/off switch Û C on the floorhead for the main power. Then press the brush-bar on/off switch Ü to activate the brush-bar motor for carpet cleaning.

IMPORTANT: To prevent damage to carpets, never leave the cleaner switched on in one place for an extended period.

IMPORTANT: The rotating brush bar will automatically stop when the cleaner is put into the upright position.

Using on hard floors

Follow steps 1-5 from the instructions for ‘Using on carpets.’

Press the brush bar on/off pedal

Üto turn the brush bar off.

Using the hose and attachments

1Take the flexible hose æ out of the storage holder.

2Pull down the hose connector inlet flap é and insert the hose connector with its ‘mouth’ pointing upwards D. Push the hose connector fully in such that the flap latches on to the connector.

3Add the required accessory directly to the tube connector ê or fit the extension tubes for maximum reach.

4When removing the connector, gently lower the flap slightly to release the catch then withdraw the connector.

IMPORTANT: With the hose connector fitted all of the suction is directed to the hose. Remove the connector before returning to general cleaning with the floor nozzle ä.

Under furniture cleaning E

The unique pivot point on this product allows the whole head to fit under low furniture for better cleaning performance.

4

UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119