turbo steam RN40655 Rev 1 23/7/04 1:34 PM Page 6
No drip system (certain models only) Your iron is fitted with a no drip system
which is designed to prevent water escaping from the soleplate when the iron is too cold.
During use, the no drip system may emit a loud click, particularly during
Auto shut-off
(certain models only)
If your iron is fitted with the auto
If the iron is left unattended in the horizontal position it will shut down after 30 seconds.
If it is left in the vertical position it will shut down after 8 minutes. When this happens the two ‘power on’ lights, situated in the back cover „ will flash to show that the iron is in
To reactivate the iron gently shake it until the ‘power on’ lights „ stop flashing and remain on.
The iron will then start to heat back up to the temperature it is set to.
Life long anti-scale system
(certain models only)
The life long
Emptying and storing
When you have finished ironing, unplug your iron.
Ensure that the
variable steam control is set at the ‘0’
position, lift up the fill cap and empty any
remaining water out of the filling hole.
Do not store in the box, but in an upright position, so that any drops of water remaining cannot leak out and discolour the soleplate.
IMPORTANT: The flex can be damaged if wound too
tightly around the iron after use. Make a loose loop with the flex and wrap it around the iron. The iron must be cool before winding the flex
and storing on its heel.
Maintenance
Jet cleaning
Your iron has a built in cleaning system designed to keep the water valve, steam chamber and steam vents clear of lint and loose mineral deposits. The ‘jet clean’ should be operated after each period of ironing.
To operate, ensure that there is little water in the tank, place the iron on its heel and turn the temperature control dial to the maximum setting. Wait for the temperature indicator light to go out, then unplug the iron and hold it about 6’’ (150mm) above the sink in the ironing position. Press the shot of steam button about 10 times in succession. After this cleaning operation, empty out any remaining water.
WARNING: Do not attempt to descale the soleplate with descaling products.
6
