RN42271MUK Rev8_Instruction Book 23/04/2013 13:42 Page 4

LOCATION

Locate the steam generator horizontally on the iron rest plate of your ironing board (if large enough) or on a heat resistant stand at the same height as your ironing board or below it. Always ensure the generator is on a firm surface when ironing.

WARNING: Do not use the product on a surface which could be damaged by heat or steam such as a worktop or a polished wood surface.

If in doubt, contact

Morphy Richards.

A

3Remove the anti-scale filter by pulling upwards B.

B

4Fill the tank to the ‘fill to

here’ line with clean tap water C.

Re-filling ‘in use’

1When the water level becomes low, the pump begins to emit a loud noise. This is due to air being pumped instead of water and is quite normal.

Refilling can be done whilst the appliance is in operation. It is not necessary to wait for the appliance to cool down.

2Slide out the water tank and fill (see filling instructions).

DRY IRONING

BEFORE USE

Remove any protective sticker from the soleplate and the base unit, if any.

Unwind and straighten the power cord · and supply cord .

Slide out the water tank and fill (see filling instructions).

Textiles and clothes are supposed to carry ironing instructions. If they don’t, you should follow the temperature guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar discreet area first.

If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing.

C

IN HARD WATER AREAS, THE USE OF DISTILLED OR DEMINERALISED WATER IS RECOMMENDED.

Never use battery topping up fluid or water containing any substances like starch, sugar, fragrant additives or defrosted water from a refrigerator.

5Re-install the anti-scale filter and re-position the water tank on the base unit and push securely into

place. Please make sure the tank is secure D.

D

1Connect the appliance to a suitable mains outlet, and switch on the socket.

2Turn the temperature dial on the iron in a clockwise direction, select dot-1, dot- 2, or dot-3 according to the recommendation of the garment label.

3The temperature indicator light glows on the iron, indicating that it is switched on.

4When the required temperature is reached, the temperature indicator light on the iron goes off. The iron is ready to use.

It is always a good idea to begin with ‘cool’ fabrics and work up to higher settings.

An iron heats up quicker than it cools down so you’ll save time and electricity.

STEAM IRONING

FILLING

1Place the steam generator on a stable ironing board or table, with the iron resting on its stand.

2Release the detachable

water tank by sliding outwards A.

6Always pour out any remaining water after use (see ‘Emptying and Storing’ on page 6).

1Unwind and straighten the power cord · and supply cord .

2Slide out the water tank and fill (see filling instructions).

4

UK Helpline 0844 871 0960 Replacement Parts 0844 873 0726 Ireland Helpline 1800 409 119

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 4
Image 4
Morphy Richards RN42271MUK manual Location, Re-filling ‘in use’, DRY Ironing Before USE, Steam Ironing Filling