Using
1Remove the lid and fill the kettle.
The integrated water level gauge/ viewing lid allows you to easily see the amount of water in this kettle.
•Always put enough water to cover the bottom of the kettle, minimum 1 cup 200cc.
•Boil only as much water as you need as this saves electricity.
2Place the kettle on the base unit, ensuring the kettle locates on to the
360o connector.
•The 360o connector allows the kettle to be located at any position - ideal for left and right handed users and convenient positioning on your
worktop.
3Plug in and switch on at the wall socket.
4Switch the kettle on. The ‘power on’ indicator neon on top of the handle will light up.
5When the water boils, the kettle will switch off automatically and the whistle will sound, to indicate that the water has boiled and has switched off
automatically.
•The whistle can be switched off for silent operation. The switch is on the underside of the base unit.
•If you are using the kettle for the first
time, pour away the boiled water and refill.
6When lifting the kettle from the base
unit by the handle ensure you hold the kettle level.
•To reboil, switch to ON again. if the kettle has just switched off wait several seconds or so before switching it back on again.
•If you do not put in enough water, or switch on the kettle when it is empty, the safety
Filter removal
1Open the lid.
2Lift the filter upwards from its location using the tab provided. Note which way you have removed the filter and replace the same way after cleaning.
3To refit the filter, slot it into the guides
and press down firmly until it clicks into place. Ensure the filter is correctly located into the central guide.
Note: Which way you have removed the filter and replace the same way after cleaning.
WARNING: Unless the filter is fitted correctly, the kettle lid may not close and lock securely.
Cleaning the filter
1To clean the filter run warm water over the mesh and scrub lightly to remove the soft deposits with a suitable brush. A toothbrush would be ideal.
2If the soft lime deposits have become hard, the filter will need descaling, see descaling page 5.
4
