70530 Rev 4 2/6/04 2:53 PM Page 6
On/off switch
1When the water tank has been filled, 'see filling the boiler,' insert the plug into the power socket.
2Switch the cleaner on by pressing the on/off switch to 'on'. The power indicator light (red) and the steam ready light (orange) will illuminate.
Steam Trigger
WARNING: At the start water may be ejected. Aim the steam safely. Start by releasing the steam into a bucket or sink.
The cleaner is now ready for use when the orange steam ready light goes out.
1Ensure the safety lock is off. When the lock is pushed forward the steam trigger cannot be activated. Push the lock to the rear position to release the steam trigger.
2When you press the steam trigger, steam will be emitted from the nozzle. Direct the steam handle at a cloth first until the steam is emitted evenly.
Steam ready display
1The steam ready light (orange) will illuminate when switched on. It will take approximately 11 minutes to reach temperature.
2When the correct temperature has been reached the steam ready light (orange) will go out. The steam cleaner is now ready to use.
Note: The steam ready light will go on and off during use. This is to keep the steam at the correct temperature.
WARNING: To avoid injury, the cleaner should be switched off during breaks or pauses of work. For extra safety apply the trigger safety lock.
If you leave the working area, please switch the cleaner off and unplug.
3Keep the steam trigger pressed and direct the steam at the surface to be cleaned, removing the dirt by moving the steam jet backwards and forwards over the area.
4To stop the steam jet, release the steam trigger.
WARNING: Do not hold the steam jet
concentrated in one place for too long.
•To control the steam temperature and the cleaning power move the handle closer to or further away from the surface.
6
