turbo steam RN40655 Rev 1 23/7/04 1:34 PM Page 4
Components of your iron
¤ ⁄ |
|
‹ | „ |
| |
› | ‚ |
| |
fi |
|
fl | · |
‡ | |
⁄ Shot of steam button |
|
¤ Spray button | ‰ |
‹ Variable steam control |
›Filling hole with cap fi Spray nozzle
fl Soleplate
‡ Illuminated temperature control dial · Water tank
‚ Life long
indicator (certain models only) ‰ Filling beaker
Before use
Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings.
When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section).
Textiles and clothes are supposed to carry ironing instructions. If they don’t you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first.
If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing.
Filling
1Make sure that the iron is not plugged in and then set the variable steam control ‹ to the ‘0’ position before filling the iron with water.
2Open the fill cap and pour water through the filling hole › into the water tank ·, using the beaker provided, one beaker full of water fills the tank (400ml). A After filling replace the fill cap. In hard water areas the use of distilled or demineralised water is recommended.
Never use battery topping up fluid or
water containing any substances like |
| |
starch, or sugar, or defrosted water from a | ||
refrigerator. | A | |
3 Always pour out the | ||
| ||
remaining water |
| |
after use. Warning: |
| |
When filling your |
| |
iron with tap water |
| |
always use the |
| |
beaker provided. |
| |
Never fill directly |
| |
under the tap. |
| |
Temperature control
Plug in the iron and switch on. The ‘power on’ indicator lights „ situated in the back cover will illuminate. Set the temperature control dial B to the temperature required, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light ‡ which will go on and off while you are ironing.
B
4
