Morphy Richards VC70465MUK manual Assembling the handle, Steam cleaning floors

VC70465MUK Rev2_Instruction Book 25/09/2012 15:00 Page 4

Assembling the handle

1

2

Insert the handle (1) into the top of the upper handle tube (4) (with the small clip on the handle below the upper cord storage hook (2) aligned with the small rectangular hole towards the top of the tube) until the handle clicks into place.

If you wish to remove the handle (1), press the metal clip at the top of the tube and lift out the handle.

Insert the lower handle tube (6) into the handle slot (7) until it clicks into place.

If you wish to remove the handle (1) (with the upper (4) and lower (6) handle tubes) when emptying the water tank (11), press the handle release button (8) and lift the handle and tubes out.

Steam cleaning floors

IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry vacuumed. However, we recommend that the steam cleaner is not used on:

•bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).

•damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).

Also, do not keep the mop in one place for an extended period, because the continual heat may cause damage to carpets and laminate flooring.

1

2

If cleaning hard floors, attach the hard-floor micro fibre cloth (18) to the fastening pads (22) on the underside of the floorhead (16). The hard-floor cloth has white fastening strips (19) on its upper side to be aligned with the fastening pads on the floorhead.

If cleaning carpet, place the carpet micro-fibre cloth (20) into the carpet glider (21) (either side up), then attach the carpet glider to the underside of the floorhead (16).

The carpet glider is designed make it easier to move the floorhead across the carpet.

4