Morphy Richards VC720506MUK manual Using in upright steam cleaning mode

VC720506MUK Rev1_Instruction Book 09/01/2014 16:42 Page 7

Using in upright steam cleaning mode (continued)

5 6

Select the desired steam level by pressing the steam level select button (12) until the indicator light next to your desired level is illuminated: low steam (19), for use on laminates and wood. medium steam (18), for use on vinyls or carpets. high steam (17), for use on ceramics.

Steam will start to be emitted around 30 seconds after the steam level select button is pressed.

Place the floorhead (22) on the floor. Hold the floorhead to the floor with your foot and tilt the steam cleaner back.

Never hold the steam cleaner continuously in one place, as excess moisture and heat may adversely affect some floor surfaces.

7 8

If cleaning carpets, rest the floorhead (22) with the micro-fibre floor cloth (27) attached into the carpet glider (31) to make it easier to move the floorhead across the carpet.

NOTE: The carpet glider is designed to make it easier to move the floorhead across the carpet and is intentionally a loose fit on the floorhead.

If attempting to steam clean a heavily soiled area on either carpet or hard floor, it may be necessary to operate the vibrate function. This will vibrate the floorhead (22) to help agitate the dust and dirt. To use this function, press the vibrate button (14). To stop the vibrate function, press the vibrate button again.

9 To enable you to more easily see the areas in need of cleaning, you may use the LED lights (25) situated in the front of the floorhead (22). Press LED light button 1 (13) to illuminate the area, and press LED light button 2 (16) if additional illumination is required.

7