73184 Rev1 9/4/08 10:42 Page 4
A |
B |
C
OPERATING THE
APPLIANCE
Using
1Assemble the cleaner as required.
2While holding the cleaner, use the plug to pull out the full length of cable. A red mark indicates the maximum length. Do not try to pull the cable past this mark.
3Connect the plug to the mains supply.
4Press the ON/OFF button.
5Check the suction control and floor nozzle controls are set as required.
6Start vacuuming.
The cleaner must be horizontal when in use. Do not use the cleaner in an upright position.
After use
1Switch off the vacuum cleaner.
2Unplug from the mains.
3Rewind the cable by pressing the rewind button.
WARNING: When using the cable rewind, always hold the plug, as the cable will rewind quickly.
The hose handle features a regulator Î which allows the suction to be reduced as required B. Closed gives full suction, open gives reduced suction.
3Attach the floor nozzle Ì to the telescopic tube.
2-position floor nozzle Ì
The brushes should be retracted for use on carpets, and extended for use on hard floors, by adjusting the lever on top of the floor nozzle.
Turbo nozzle
(certain models only) Ó
This nozzle is suitable for cleaning and rejuvenating cut pile carpets and is ideal for picking up stubborn dirt and pet hairs.
Cleaning the turbo nozzle:
The turbo nozzle should be regularly cleaned and any hairs or fibres wrapped around the brush bar removed to maintain optimum performance.
Hand Tools
The crevice tool / brush (for awkward places, behind radiators etc.) and the upholstery nozzle (for curtains and upholstery) are stored inside the cleaner under the cover C.
| TOOLS AND |
D | ACCESSORIES |
1Fit the hose to the cleaner by inserting the hose end into the hose inlet ⁄. When removing,
squeeze the clips either side and pull.
2Attach the telescopic tube.
Extend to the required length by pushing up the slider release and pulling out the tube A.
Slide the cover release button
·to open the cover.
The crevice tool has a
Storage hook
A slot is provided on the base of the cleaner to allow neat storage of the hose and tubes after use D.
4 | UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119 |
