3:DONE
Exit the channel setting and menu mode.
Setting the Delay
2:SCAN OPTION → 1:CONVENTIONAL → Channel No. → 2:DELAY
The delay option lets you set a delay after a transmission for each channel. This slows down scanning, but helps to prevent missing replies.
1:NONE
The delay is turned off.
2:1 SECOND
The delay time is 1 second.
3:2 SECONDS
The delay time is 2 seconds.
4:4 SECONDS
The delay time is 4 seconds.
5:INFINITE
When the scanner stops on a transmission, you must press RSM to resume searching.
6:
The scanner only stops on transmissions for 2 seconds, then automatically resumes. To hold on the transmission, press ▲/HOLD during the
7:
The scanner only stops on transmissions for 5 seconds, then automatically resumes. To hold on the transmission, press ▲/HOLD during the
8: -10 SECONDS
The scanner only stops on transmissions for 10 seconds, then automatically resumes. To hold on the transmission, press ▲/HOLD during the
Setting the Subaudible Tone Option
2:SCAN OPTION → 1:CONVENTIONAL → Channel No. → 3:TONE DATA
Some radio systems use special tones to prevent interference from other nearby systems operating on the same frequencies. When tones are being used, the radios only open squelch when a transmission with a matching tone is present on the frequency. Some services, such as FRS, GMRS, and Business Band refer to these tones as Quiet Codes, Privacy Codes, or similar and use a number to associate a particular tone. The table in the back of the manual provides a cross reference to common associations. For this feature to work, you need to turn on the Tone Mode (see “Setting Squelch Mode”).
1:CTCSS
Continuous Tone Coded Squelch System (CTCSS) is used with Amateur Radio, FRS, GMRS, Business Band, and other systems. When you select this option, the scanner only opens squelch when a matching CTCSS tone is present on the frequency.
2:DCS
38
