Motorola LS1013 Securing workpiece, Sub-fence, Sub-fence R (optional accessory), Vertical vise

Securing workpiece

WARNING :

•It is extremely important to always secure the

workpiece properly and tightly with the vise. Failure

to do so can cause the tool to be damaged and/or

the workpiece to be destroyed. PERSONAL

INJURY MAY ALSO RESULT. Also, after a cutting

operation, DO NOT raise the blade until the blade

has come to a complete stop.

CAUTION:

•When cutting long workpieces, use supports that

are as high as the top surface level of the turn base.

Do not rely solely on the vertical vise and/or

horizontal vise to secure the workpiece.

Thin material tends to sag. Support workpiece over

its entire length to avoid blade pinch and possible

KICKBACK.

Sub-fence

This tool is equipped with the sub-fence which should

ordinarily be positioned as shown in the figure.

However, when performing left bevel cuts, set it to the left

position as shown in the figure.

CAUTION:

•When performing left bevel cuts, flip the fence over

to the left position as shown in the figure.

Otherwise, it will contact the blade or a part of the

tool, causing possible serious injury to the operator.

Sub-fence R (optional accessory)

The sub-fence R can be installed on the right side of the

guide fence. Insert the rods of the sub-fence R into the

holes in the guide fence. Tighten the screws which come

with the sub-fence R to secure the sub-fence R.

CAUTION:

•When performing right bevel cuts, never use the

sub-fence R. It will contact the blade or a part of the

tool, causing possible serious injury to the operator.

Vertical vise

The vertical vise can be installed in two positions on

either the left or right side of the guide fence or the base.

Insert the vise rod into the hole in the guide fence or the

base and tighten the screw on the back of the guide

fence to secure the vise rod.

Position the vise arm according to the thickness and

shape of the workpiece and secure the vise arm by tight-

ening the screw. If the screw to secure the vise arm con-

tacts the guide fence, install the screw on the opposite

side of vise arm. Make sure that no part of the tool con-

tacts the vise when lowering the handle fully and pulling

or pushing the carriage all the way. If some part contacts

the vise, re-position the vise.

1. Support

2. Turn base

1. Sub-fence

001549

001545

1. Sub-fence

1. Sub-fence R

2. Screws

1. Vise arm

2. Vise rod

3. Screw

4. Vise knob

5. Guide fence

001546

001547

001548