Instructions for Econo Plus Feeder Kit
THANK YOU for your purchase of the Econo Plus Feeder Kit. Please read this sheet before operating the unit. If you should have any questions about this product or any other Moultrie product, please contact us using the information below. To help us to better serve you, please complete and mail the enclosed Warranty Card.
DRILLING YOUR DRUM/BARREL/BUCKET
Econo Plus Feeder will mount to the bottom of any drum or bucket
CAUTION: WEAR EYE PROTECTION
Turn drum over, measure and mark the center of the bottom.
Center the template on the bottom of the drum and secure with tape. Drill two 3/16" Funnel holes and three 5/16" Feeder Leg holes.
Funnel Holes
Feeder Leg Holes
Using a Hole Saw, drill a
MOUNTING THE FEEDER
Place Funnel inside Drum with small end of funnel facing down, and attach with two Short Bolts using nuts and washers provided.
Turn Drum upside down.
Place Feeder on Drum. Attach Feeder Legs to Drum as shown with Long Bolts using nuts and washers provided.
Short | Bolts |
Bolts |
|
Drum 
Funnel 
Feeder
Feeder Legs 
Long
Bolts
Drum
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna • Increase the separation between the equipment and the receiver
