CONNECTING POWER CABLE
c a u t i on: wea r ey e pr ot ec t i on
Make sure the power switch is in the OFF position. Connect the provided Power Cable to the motor switch via the black connectors. Connect to ATV’s battery by attaching the Red Alligator Clip to the positive terminal (+), and the Black Alligator Clip to the negative
ADDING MATERIAL AND ADJUSTING AMOUNT
Add desired material such as feed, fertilizer, seed, etc. to hopper and attach lid. Verify that Ratchet Strap is tight enough to hold the top of the hopper perpendicular to the ATV rack.
The Adjustment Stop allows you to set the amount of feed dispensed. Move Adjustment Stop towards the front of the ATV to dispense less material. Move the Adjustment Stop towards the rear of the ATV to dispense more material.
OPERATING UNIT
Adjustment Stop 
Move towards Front to dispense Less
Move towards
Rear to
Mounting 
dispense More
Bracket 
c a u t i on: wea r ey e pr ot ec t i on
Turn the Motor Switch to the ON | Feedgate Arm |
|
|
| |||
|
|
| |
position. |
|
|
|
To spread material, Pull the Spreader’s | Adjustment Stop | ||
|
|
| |
Feedgate Arm towards you to Open the |
|
|
|
feedgate and Push arm away from you to | |||
Close. Reposition Adjustment Stop as |
|
|
|
appropriate. |
|
|
|
CLEANING AND STORING UNIT
NOTE: FERTILIZER IS EXTREMELY CORROSIVE. After spreading material, completely wash and dry ATV Spreader. A light coat of oil on all metal parts and motor will help prevent rust- ing and corrosion.
1:(Q) Can I leave the ATV Spreader connected to my ATV when it is not in use? (A) Yes, however to reduce the possibility of damage to the spreader, it is highly recommended that the hopper is empty.
2:(Q) Should I operate my ATV differently when the ATV Spreader is loaded?
(A) Yes, the additional weight in the rear of the ATV will cause the
and down hills due to this shift in weight.
3:(Q) What is the best way to set the dispensing amount? (A) Set the adjustment stop to the position in which you feel will provide the best coverage. Turn on spreader and open the Feedgate. Spread material for about 20 feet and then walk back to verify coverage. Reposition Adjustment Stop as appropriate.
4:(Q) Can I get replacement parts for my ATV Spreader? (A) Yes, you may purchase the following Moultrie replacement parts.
• Directional Shroud |
|
• Backplate | |
• Bolt Pack | |
• Motor | |
• Wire Harness | |
• Spin Plate | |
• Hitch Pins |
Our Service Department will gladly answer any questions you have.
Call
061604R 9 / MFHP53772
