3Operating Instructions and Owner’s ManualMr. Heater | Gas-Fired Infra-Red Portable Heater
HOOK-UP INFORMATION
1.1 Heater model MH12T and MH12TS are packaged completely.
Propane cylinders (tanks) are not included with heater model.
1.2 Remove heater from carton.
1.3 Use only LP gas cylinders constructed for use with propane only
gas cylinders of the U.S. Department of Transportation (DOT
SPEC. 39).
1.4 This heater must be used only with a vapor withdrawal LP gas
bulk tank equipped with a standard POL valve – do not use this
heater on bulk tanks greater than 20 pounds LPG capacity (50
pounds water capacity).
2.1 Mount heater to bulk tank.
2.2 Hold heater vertically in one hand (see Fig. 1) and with the
other hand carefully turn POL nut counterclockwise into bulk
2.3
a well-ventilated area and complete mounting with a 7/8”
open end wrench (see Fig. 2) turning counterclockwise (left
hand thread) until tight, see Para. 5 for additional assembly
procedure.
2.4 WARNING
Never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
2.5 Read pages 3 and 4 before lighting heater.
TIGHTEN
Figure 2

MODEL MH12T

MODEL MH12TS

WITH SPARKLITE

FACE
GUARD
HEATER
REFLECTOR
CYLINDER
ON-OFF VALVE
BULK
CYLINDER
Figure 1