Magnet & Sensor
!Use a coin to attach the wheel magnet q temporarily to the right side spoke of front wheel.
Caution: Attach the sensor and the magnet within 10cm from the hub axle.
Spoke
#Attach the cadence sensor 3 temporarily to the left chain stay.
Chain stay
Wire
%Secure the wire along the frame using the nylon ties 6
and wind it round the brake cable up to the handlebar. Caution: Allow enough wire clearance in the area marked
with 
.
@Attach the speed sensor 2 temporarily to the right front fork. Adjust the sensor 2 and the magnet q referring to the conditions A and B . After adjusting, tighten the screw 0 and the magnet q.
Front fork
$Attach the cadence magnet w to the crank. Adjust the position of the sensor and the magnet referring to the conditions A and B . After adjusting, fix the cadence magnet w with the adhesive tape and the nylon tie 6.
Crank
Reference:
If the clearance between spoke and front fork is wider than 5mm, mount the sensor band 3 and 4in an opposite way as shown.
Bracket
Attach the bracket rubber pad with holder 9 to the bracket
1and mount it to the handle bar.
Reference: If it does not fit well, use the rubber pad 8.
