Gas and Oil Fill-Up
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your mower. Read instructions carefully.
WARNING: Never fill fuel tank indoors with engine running or until the engine has been allowed to cool for at least two minutes after running.
Starting Engine
•Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug is fastened securely over the metal tip on the spark plug.
•Prime engine as instructed in the separate engine manual packed with your unit.
•Your lawn mower may be equipped with a constant speed throttle, which is set at full throttle for best performance.
•Stand behind the mower and squeeze the blade control handle against the upper handle.
•Grasp recoil starter handle and pull rope out slowly until engine reaches the start of compression cycle (rope will pull slightly harder at this point). Let the rope rewind slowly. Pull rope with a rapid, continuous, full arm stroke. Keeping a firm grip on the starter handle, let the rope return to the starter slowly.
Using Your Lawn Mower
Be sure that the lawn is clear of stones, sticks, wire, or other objects which could damage the lawn mower or the engine. Such objects could be accidently thrown by
the mower in any direction and cause serious personal injury to the operator and others.
For best results, do not cut wet grass because it tends to stick to the underside of the mower, preventing proper discharge of grass clippings, and could cause you to slip and fall. New grass, thick grass, or wet grass may require a narrower cut.
For a healthier lawn, never cut off more than
WARNING: If you strike a foreign object, stop the engine. Remove wire from the spark plug, thoroughly inspect the mower for any damage, and repair the damage before restarting and operating the mower. Extensive vibration of the mower during operation is an indication of damage. The unit should be promptly inspected and repaired.
Mulching
For effective mulching, do not cut wet grass because it tends to stick to the underside of the deck, preventing proper mulching of grass clippings. New or thick grass may require a narrower cut. The ground speed should be adjusted to the condition of the lawn. If mowing has been delayed and the grass has been allowed to grow in excess of 4”, mulching is not recommended. Mow using the side discharge to reduce the grass height to 3 1/4” maximum before mulching.
SECTION 6: MAKING ADJUSTMENTS
Cutting Height Adjustment
Height Adjustment |
Lever |
Figure 9
WARNING: Always stop engine, discon- nect spark plug, and ground against engine before performing adjustments.
Each wheel has a height adjustment lever which provides cutting height adjustment. When the adjustment lever is moved from one location to another the height of cut will be changed. Simply depress the lever towards wheel and move lever assembly to desired position. See Figure 9.
IMPORTANT: All wheels must be placed in the same relative position. For rough or uneven lawns, move the height adjustment lever to a higher position. This will help stop scalping of the grass.
10
