Charging
WARNING! Batteries give off an explosive gas while charging. Charge the battery in a well ventilated area and keep away from an open flame or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances.
Caution: When charging your tractor’s battery, use only a charger designed for 12V
If your tractor has not been put into use for an extended period of time, charge the battery as follows:
1.Set your battery charger to deliver a max of 10 amperes.
2.If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight hours.
Fuse
WARNING! Before servicing, repairing, or inspecting, always disengage PTO, set parking brake, stop engine and remove key to prevent
unintended starting.
A fuse is installed in your tractor’s wiring harness to protect the tractor’s electrical system from damage caused by excessive amperage.
If the electrical system does not function, or your tractor’s engine will not crank, first check to be certain that the fuse has not blown. It is located under the hood, mounted behind the top of the dash panel on the support bar.
Caution: Always use a replacement fuse with the same amperage capacity as the blown fuse.
Tires
WARNING! Never exceed the maximum inflation pressure shown on the sidewall of the tire.
Refer to the tire sidewall for exact tire manufacturer’s recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow unevenly.
Changing the Transmission Drive Belt
Several components must be removed and special tools used in order to change the tractor’s transmission drive belt. See your authorized service dealer to have the transmission drive belt replaced.
28
Section 7— Service
