drain oil from both left and right axles. Replace and retighten nuts.

Transmission

Figure. 9

j.Coat new filter seal with oil before installa- tion. Install new hydraulic oil filter filled with new oil.

k.Add proper amount of hydraulic oil to res- ervoir.

l.Run and purge gearboxes. Check oil level.

m.Add proper amount of hydraulic oil to res- ervoir and repeat step L.

C.Electrical Circuit

Danger:

Read General Safety Precautions Nos. 9 and 10.

1.Battery: The battery is located beneath the operator’s seat. Remove the fillcaps and check the level of the liquid electrolyte in the battery every 50 operating hours. If the level in any of the six cells has dropped below the bottom of the split ring inside the fill hole, refill the cell with distilled water. To keep the out- side of the battery clean, brush on a strong solution of bicarbonate of soda and water and rinse with clean water. Keep the contacts and cable ends clean with a wire brush and make sure the connections are tight. Coat the termi- nals with petroleum jelly to prevent corrosion.

2.Battery Storage: When storing the Mower for long periods of time the following guidelines should be taken.

a.Disconnect the battery cables from the ter- minals and remove the battery. You will have to remove the control panel to access the battery strap. Replace control panel.

b.Clean the battery before storing. A dirty battery will lose its charge over time.

c.Store the battery with a full charge. A dis- charged battery will freeze (refer to the table below)..

Specific Gravity

Freezing Temp (°F)

 

 

1.265

-71

 

 

1.250

-62

 

 

1.200

-16

 

 

1.150

5

 

 

1.100

16

 

 

d.Recharge battery when ever the specific gravity value is less than 1.225

3.Battery Removal

Warning:

When removing the cables from the battery follow these steps to avoid a short between the wrench and the frame.

a.Remove the Negative (black) cable.

b.Remove the Positive (red) cable.

c.Release the hold down straps.

d.Remove the battery without tipping.

4.Installing the Battery

Note: The battery is delivered from the fac- tory fully charged and filled with electrolyte.

a.Attach the Positive (red) cable.

b.Attach the Negative (black) cable.

c.Attach the rubber battery strap.

5.Jump Starting

Warning:

Failure to use this starting procedure can cause sparking, and the gases in the battery to explode.

a.Attach the end of the red jumper cable to the Positive terminal (+) of the charged battery.

b.Attach the other end of the red jumper cable to the Positive terminal (+) of the low charge battery.

c.Attach the end of the black jumper cable to the Negative terminal of the charged bat- tery.

d.Attach the other end of the black jumper cable to the frame of the unit with the low charge battery.

6.Fuses: There is one fuse located in the wiring between the ignition and start switch and

17

Page 17
Image 17
MTD 18HP Electrical Circuit, Specific Gravity Freezing Temp F, Battery Removal, Installing the Battery, Jump Starting

18HP specifications

The MTD 18HP is a robust and reliable lawn tractor that has gained popularity amongst gardening enthusiasts and homeowners alike. This machine is designed to provide efficient performance while maintaining a user-friendly experience. One of the standout features of the MTD 18HP is its powerful 18 horsepower engine, which ensures that users can tackle even the toughest mowing tasks with ease. The engine is engineered to deliver impressive torque, making it suitable for a variety of environments and terrain types.

One of the key technologies integrated into the MTD 18HP is its hydrostatic transmission system. This feature allows for smooth and seamless operation, enabling the operator to effortlessly control the speed and direction of the mower without the need for shifting gears. This element greatly enhances the overall user experience and makes the machine easier to handle, especially for those who may be new to operating tractors.

The cutting deck of the MTD 18HP is another remarkable attribute. Typically featuring a 42-inch or 46-inch cutting width, the deck is designed for efficient grass cutting and allows for quick maneuverability around obstacles. With multiple cutting height adjustments, users can customize their mowing height to suit their lawn's specific needs. The durable construction of the cutting deck also aids in extending the lifespan of the mower while ensuring that it can withstand challenging mowing conditions.

Additionally, the MTD 18HP is equipped with ergonomic controls that enhance comfort during operation. The contoured seat and easy-to-reach controls promote a more enjoyable mowing experience, reducing fatigue during extended usage. The tractor also features large rear wheels that provide excellent traction and stability on uneven terrain.

Safety is a priority with the MTD 18HP, which includes features such as an automatic blade brake that engages when the operator leaves the seat, preventing any accidental injury.

In summary, the MTD 18HP is a powerful, user-friendly lawn tractor that combines impressive engine performance with innovative technologies and thoughtful design features. From its hydrostatic transmission to its adjustable cutting deck and ergonomic controls, this tractor is well-equipped to handle a range of yard maintenance tasks with ease and efficiency. Whether for residential or light commercial use, the MTD 18HP remains a solid choice for those who seek reliability and performance in their lawn care equipment.