MTD 2N1 Snow Thrower Setup, Positioning the Upper Handle, Chute Assembly, Figure Figure Figure

3

Snow

Thrower

Setup

NOTE: This Operator’s Manual covers several models.

Not all features refer- enced in this manual are applicable to all snow thrower models.

NOTE: All references to left or right side of the snow thrower is from the operating position only.

IMPORTANT: Do not use the chute handle to lift the snow thrower.

Figure 3-1

Figure 3-2

Figure 3-3

Positioning the Upper Handle

1.Remove packing material, if present.

2.Raise the upper handle in the direction shown in Figure 3-1 until it clicks into the operating position. Make sure not to pinch or crimp the cable.

3.Tighten the knobs. See Figure 3-2.

Chute Assembly

Rotate the discharge chute to the left or right using chute handle. The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; tilt down for less distance. See Figure 3-3.

Loosen the hand knob on the side of the discharge chute to adjust. Tilt the chute to the desired position, and tighten the knob.

IMPORTANT: Do not use the chute handle to lift the snow thrower

6