Adjusting the Cutting Height

The cutting height can be adjusted to between approximately 3/4-inch and 21/2-inches.

1.Move the right-hand height adjustment lever outward and then position it forward (to lower the cutting height) or rearward (to raise the cutting height) before releasing it into the notch for your desired height. See Fig. 3-4.

Figure 3-4

2.Repeat Step 1 on the left-hand side making sure to release the height adjustment lever into the corresponding notch.

Attaching the Grass Catcher (Model 3100)

1.Expand the grass catcher from its collapsed position by opening up the hinges found on the inside of its frame.

2.Position the grass catcher hooks over the rod on the rear of the mower. See Fig. 3-5.

Figure 3-5

3.Positionthestrapthroughthegrasscatcher’shandleandover the mower’s lower handle crossbar to support the rear

of the grass catcher. See Fig. 3-6. Adjust the length of the strap so that the bag is low to the ground but not dragging on the ground.

Figure 3-6

6Section 3 — Assembly & Set-Up