MTD 30 Spark Plug Wire, Attaching The Handles, Attaching Lower Handle, Attaching Upper Handle

Blade Control *blade

Handle* control may be detached

Upper Handle Lower Handle

Figure 3-2: The upper and lower handles.

2

1

Figure 3-3: Attach the lower handle to the brackets on deck.

Figure 3-4: Attach the upper handle to the lower handle.

Spark Plug Wire

Disconnect spark plug wire from the spark plug and ground it against the engine. If engine is equipped with a rubber boot, attach rubber boot to a bolt on the engine. This will prevent the engine from firing during assembly.

Attaching The Handles

The lower handle has two flat ends with three holes each, one small and two large. The upper handle has indented ends with one hole and may have the blade control handle attached, Figure 3-2.

Attaching Lower Handle

NOTE: Use the hardware in Group 1 to attach the lower handle.

1.Place the lower handle over the handle bracket assemblies and position each bracket stud into the top or bottom hole, Figure 3-3.

2.Secure with the star knobs, Figure 3-3. Each side of the lower handle must be positioned onto the stud at the same position.

Attaching Upper Handle

NOTE: Use the hardware in Group 2 to attach the upper handle.

1.Place the upper handle in position over the lower handle keeping the blade control handle facing up.

2.Secure the upper handle to the lower handle using the carriage bolts and star knobs, Figure 3-4. Make sure that the carriage bolt heads go on the outside of the handle.

3

Setup and

Adjustment

Reference to right, left, front, or back of the lawn mower is from the operating position only, unless otherwise stated.

7