7.Locate the carriage bolt, bell washer and hand knob packed with your unit.
8.Insert the carriage bolt through the welded
bracket on the handle, bell washer, handle brace and into the hand knob.
See Figure 3–4.
9. Select one of the three handle height
positions (three notches in welded handle |
| |
bracket) and tighten the hand knob to secure |
| |
the handle in the desired position. | Figure | |
Figure | ||
| ||
tighten the hex bolt securely |
| |
Depth Gage Attachment |
| |
1. Disassemble the depth gage assembly as |
| |
seen in Figure |
| |
later reassembly. |
|
Figure
2. Remove the two screws from the rear of the tiller frame as shown in Figure
3. Insert the depth gage bracket into the frame and reinstall the two screws removed earlier. Tighten the hex bolts securely.
See Figure 3–6.
Figure
4. Insert the depth stake into the depth gage bracket assembly as seen in Figure
of this manual.
Figure
3
Assembly
NOTE: Stand behind the tiller as if you were going to operate it. Your right hand corresponds to right side of
tiller; your left hand
corresponds to left side of tiller.
IMPORTANT
This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the accompanying engine manual BEFORE operating your tiller.