4
Know
Your Snow
Thrower
WARNING
Become familiar with all the controls on the snow thrower and their proper operation. Know how to stop the machine and disengage them quickly.
Never make adjustments to the chute assembly unless both auger and drive
WARNING: Be familiar with all the controls on the snow thrower and their proper operation. Know how to stop the machine and disengage them quickly.
Compare Figure 7 with your equipment and follow description of controls, given below, to become familiar with their operation.
Auger Control
|
| Upper Handle |
| |
Starter Rope |
| Drive Control |
| |
|
|
|
| |
Gasoline Cap |
|
|
|
|
Upper Chute | Chute Handle |
|
| |
|
|
| ||
Chute Assembly |
| Muffler | Oil Fill | Fuel Cap |
|
|
| Spark | |
|
|
|
| |
|
| Plug |
| |
|
| Carburetor |
| |
| Chute Knob | Cover |
|
|
Auger |
| Choke |
| Starter |
Skid Shoe | Throttle |
| Handle | |
Shave Plate |
|
| ||
| Control | Oil Drain | Primer | |
|
| |||
|
|
| ||
| Figure 7 |
|
|
|
controls are disengaged and the operator is stand- ing beside the unit.
Throttle Control
The throttle control is located on the engine. It regulates the speed of the engine and also stops the engine.
Drive Control
Located on the underside of the upper handle, the drive control is used to engage/disengage wheels. Squeeze the drive control against the upper handle to engage the wheels; release to disengage.
Auger Control
The auger control is adjacent to the upper handle. Squeeze the auger control against the upper handle to engage the augers; release to disengage the augers.
WARNING: Never make adjustments to the chute assembly unless both auger and drive controls are disengaged and
the operator is standing beside the unit.
IMPORTANT: Refer to the Auger Control Test in the Operation section prior to operating your snow thrower. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.
Gasoline Cap
Remove gas cap to add fuel. Unit runs on regular gas.
Chute Handle
The direction of snow throwing corresponds to the direction of the chute opening. Use the chute handle to turn the chute assembly in the direction you wish to throw the snow.
Chute Knob
The distance snow is thrown can be adjusted by either raising or lowering the upper chute. Loosen the chute knob on the side of the upper chute to adjust. Pivot the upper chute to desired position, and retighten the chute knob.
Ignition Key
The ignition key is necessary for the engine to start. Insert key and snap in place; Do not turn it to start/stop the unit. Remove key when the unit is not in use.
Shave Plate
The shave plate maintains contact with pavement as the snow thrower is propelled, allowing snow close to pavement’s surface to be discharged.
Skid Shoe
The space between the shave plate and the ground can be adjusted. For close snow removal, place skid shoes in the low position. Use middle or high position when area to be cleared is uneven or on gravel surfaces.
