Idler Pulley Rod
Belt Keeper |
|
Bracket | Idler Bracket |
Engine Pulley |
|
Figure |
|
•Remove the belt keeper bracket located behind the engine pulley by removing two hex bolts and lock washers. See Figure
•Remove belt and reassemble new belt. Follow instructions in reverse order.
NOTE: Upon reassembly, make certain the belt is routed over the idler pulley and inside of belt keepers by engine pulley. See Figure
Off-Season Storage
If the tiller will not be used for a period longer than 30 days, the following steps should be taken to prepare the tiller for storage.
•Clean the exterior of engine and the entire tiller thoroughly. Lubricate the tiller as described in the lubrication instructions.
•We do not recommend the use of pressure washers to clean your unit. They may cause damage to electric components, spindles, pulleys, bearings or the engine. The use of pressure washers will result in shortened life and reduce serviceability.
•Refer to the engine manual for correct engine storage instructions.
•Wipe tines with oiled rag to prevent rust.
•Store tiller in a clean, dry area. Do not store next to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment and especially any springs, bearings, and cables.
8
Off-Season
Storage
When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment and especially any springs, bearings, and cables.
NOTE: Specifications are subject to change without notification or obligation.
Images my not reflect your exact model and are for reference purposes only.
13
