MTD 469 manual Making Adjustments, Replacing Rear Flap, Handle Height

Models: 469

1 17
Download 17 pages 38.9 Kb
Page 14
Image 14
Replacing Rear Flap

 

Loosen this screw

 

Belt

 

Shoulder

 

Screw

 

Shoulder

 

Screw

Transmission

Front Drive

Cover

 

Figure 14

Slide the belt off the engine pulley and around the blade. See Figure 15 .

WARNING: As always, use a thick piece of rag to handle the blade while sliding the belt around it. Make sure the engine does not start at all while doing this job.

Replace with the new belt, working around the blade. Make sure the belt is firmly seated on the engine pulley while pulling from the other side and sliding it around the transmission pulley.

Put the mower down with all four wheels firmly placed on one level.

Tighten the screw, loosened earlier, to secure the belt tension spring to the transmission, and reassemble the front drive cover.

Right Front

Left Front

Wheel

Wheel

 

Engine

 

Pulley

Figure 15

Replacing Rear Flap

To remove rear flap, cut off the flat end of the wire rod which secures it to the deck. See Figure 16 .

Attach the new flap and new rod to deck, bending the ends of the new rod over to secure to deck.

Rear Discharge

Door

Handle

Bracket

d

o

R

e

r

i

W

Handle

Bracket

Rear

Flap

Figure 16

SECTION 8: MAKING ADJUSTMENTS

Handle Height

Your mower is shipped with the handle in the higher height position. To lower height, proceed as follows.

Remove the starter rope from the rope guide.

Remove the upper handle by removing the hand knobs and carriage bolts. Lay the upper handle out of the way, being careful not to bend or kink cables.

Remove the hairpin clips from the weld pins on the handle brackets. Refer to Figure 4 . Press out on

the legs of the lower handle. Remove lower handle from the mower.

Turn lower handle around so the notch is facing forward as shown in Figure 17 . Reassemble, placing the bottom holes in the handle over the weld pins in the handle mounting bracket.

Reassemble the upper handle to the lower handle.

Insert hairpin clips in the inner holes of the weld pins and attach the starter rope as instructed in “Assembling Your Lawn Mower” section.

14

Page 14
Image 14
MTD 469 manual Making Adjustments, Replacing Rear Flap, Handle Height