Drive Control

When the drive control is released and in the disengaged “up” position, the cable should have very little slack. It should NOT be tight.

NOTE: If excessive slack is present in the drive cable or if the snow thrower’s drive is disengaging intermittently during operation, the cable may be in need of adjustment.

Check the adjustment of the drive control as follows:

1.With the drive control released, push the snow thrower gently forward. The unit should roll freely.

2.Engage the drive control and gently attempt to push the snow thrower forward. The wheels should not turn. The unit should not roll freely.

3.With the drive control released, move the shift lever back and forth between the R2 position and the F6 position several times. There should be no resistance in the shift lever.

4.If any of the above tests failed, the drive cable is in need of adjustment. Proceed as follows:

5.Loosen the lower hex nut on the drive cable bracket. See Fig. 6-5.

Figure 6-5

6.Position the bracket upward to provide more slack (or downward to increase cable tension).

7.Retighten the upper hex nut.

Section 6 — Maintenance & Adjustments

 

17