LIFT LEVER | BRAKE PEDAL |
BRAKE 
The lift lever is used to change the operating position (height) of the cutting deck. To operate, move the lever to the left, then place in the notch best suited for your application.
PTO (POWER TAKE-OFF) LEVER
The brake pedal is located on the right front side of the tractor above the drive pedal along the running board. The brake pedal can be used for sudden stops or for setting the parking brake.
NOTE: The brake pedal must be fully depressed to activate the safety interlock switch when starting the tractor.
The PTO lever is located on the left side of the dash next to the steering wheel. Move the PTO lever forward to engage the power to the cutting deck or other attachments; move the PTO lever backward (toward the rear of the tractor) to disengage the power to the attachments.
NOTE: The PTO lever must be in the disengaged (OFF) position when starting the engine, when shifting into reverse and if the operator leaves the seat.
DRIVE PEDAL
The drive pedal is located below the brake pedal on the right front side of the tractor along the running board. Depress the drive pedal with your right foot when the tractor shift lever is in either forward or reverse to cause the tractor to move. Ground speed is also controlled with the drive pedal. The further down the pedal is depressed, the faster the tractor will travel. The pedal will return to its original position when it’s not depressed.
IMPORTANT: Always set the parking brake when leaving the tractor unattended.
PARKING BRAKE BUTTON
To set the parking brake, fully depress | P |
the brake pedal and push the parking | |
brake button in. Hold the button in |
|
while taking your foot off the brake |
|
pedal. Both the parking button and |
|
the brake pedal will then stay |
|
depressed. To release the parking |
|
brake, depress the brake pedal |
|
slightly. The parking brake button will |
|
then return to its original position. |
|
NOTE: The parking brake must be set if the operator leaves the seat with the engine running or the engine will automatically shut off.
IMPORTANT: Always set the parking brake when leaving the tractor unattended.
SHIFT LEVER |
| F | |||
The shift lever is located | |||||
on the left side of the |
| ||||
fender | and | has | three |
| |
positions, | FORWARD, |
| |||
NEUTRAL and REVERSE. |
| ||||
The brake pedal must be |
| ||||
depressed and the tractor | N | ||||
must not be in motion | |||||
when | moving | the | shift |
| |
lever. |
|
|
|
|
|
IMPORTANT: Never | Shift | ||||
force the shift lever. Doing | Knob | ||||
so may result in serious | R | ||||
damage to | the | tractor’s | |||
transmission. |
|
|
|
| |
10
