Slope Gauge | MTD 760, 779, 760-779 specs

Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes.

��	��
��	��

Slope

Gauge

WARNING

Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately

2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk- behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury.

Operate RIDING mowers up and down slopes, never across the face of slopes.

Operate

WALK-BEHIND mowers across the face of slopes, never up and down slopes.

Page 3

Image 3

MTD 760, 779, 760-779 warranty Slope Gauge

Contents

01/06/2006 MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Table of Contents Slope Gauge This power machine to persons who read, understand Use only an approved gasoline containerReplace gasoline cap and tighten securely General Operation Never allow children or others in or on towed equip- ment Do Not Service Attaching the Battery Cables Gas and Oil Fill-upRemove the hex bolt and hex nut from the negative cable Attaching The Steering Wheel Shipping Brace Removal Attaching The Seat Standard Adjustment SeatQuick Adjustment Seat Knob Adjustment Seat Equipped Identifying the Mulch Plug if so Operating Always disengage Ignition SwitchThrottle Control Lever Choke Control Shift Lever Safety Interlock SwitchesParking Brake Clutch-Brake Pedal To use the Reverse Caution Mode Reverse Caution Mode If EquippedModels without Reverse Caution Mode Models with Reverse Caution Mode Setting the Cutting Height Starting the EngineStopping the Engine Place shift lever in Neutral Restart engine Driving The Tractor Mowing Using the Deck Lift LeverDriving On Slopes Engaging the Blades Mulching If Equipped Headlights Side to Side Parking Brake AdjustmentLeveling the Deck Front To Rear Standard Seat Seat AdjustmentKnob Adjustment Seat if so equipped Quick Adjust Seat If so equipped Cleaning the Engine And Deck EngineLubrication Cutting Deck Removal Deck Wash SystemTo remove the cutting deck, proceed as follows Fuse Battery Cutting Blades Blades may be removed as followsFoot-pounds Remount the belt guards removed earlier Changing the Deck Belt & PTO BeltChanging the Transmission Drive Belts Remove the belt keeper rod from around the engine pulley Maintaining Your Lawn Tractor Twin Bagger Grass Collector for 38/42-inch Decks Rear Wheel Weight KitInch Two-stage Snow Thrower 38/42-inch Deck Mulch Kit Your Responsibility Restrict the use Safety Labels Choke not activated Spark plug wires loosePlug wires Fuel tank empty or stale fuel High RPM Gap Idles poorly Fins and blower housingToo wide Gap Dirty air cleaner Spark plugs gap too closePage Page Page MANUFACTURER’S Warranty Coverage MANUFACTURER’S Limited Warranty for