ASSEMBLY INSTRUCTIONS

Adjustment

7.Loosen the screws so that the J-handle easily moves in the clamp assembly. Do not remove the screws or nuts.

8.Slide the J-handle in or out until the arrow/white line on the decal touches the clamp assembly. See Figure 4.

Decal

FIGURE 4

9.While holding the unit in the operating position, arrange the J-handle in the location that provides you with the best grip. See Figure 5.

FIGURE 5

10.Tighten the clamp screws evenly, until the J-handle is secure.

INSTALL THE HARNESS

WARNING: To avoid personal injury, always use the shoulder harness when using the cutting blade.

1.Push the strap through the center of the buckle.

2.Pull the strap over the cross bar and down through the slot in the buckle. See Figure 6.

FIGURE 6

3.Put the harness on over your head and onto your shoulder. Snap it on to the support fitting. See Figure 7.

Support Fitting

FIGURE 7

4.Adjust length to fit the operator’s size. Pull tab to lengthen, pull strap to shorten. See Figure 8.

FIGURE 8

7