7
SECTION 3: CONTENTS OF HARDWARE PACK
Hardware pack may contain extra items which are not used on your unit. Part numbers are shown in parentheses.
SECTION 4: ASSEMBLING YOUR LAWN MOWER

Loose Parts in Carton

Grass Catcher Assembly.
Owner’s Manual (not shown).
Hardware Pack.
Upper and Lower Handle w/ Guide Rod.
Wheel Assemblies (4)

Too ls Req ui re d

Phillips head screwdriver.
Adjustable wrench, a wrench set or socket set.

Attaching Wheels

The wheels for your mower will not require tools to
install. Notice that there are two large wheel assemblies
and two smaller wheel assemblies. The large wheels fit
on the rear and the small wheels are for the front of the
mower. To install the wheels:
Rest the mower on its side or place supporting
blocks under one side of the mower.
Refer to Figure 1 and insert the hubcap assembly
through the wheel and thread the complete
assembly into the desired height adjustment
position by hand.
NOTE: It is recommended to use the highest cutting
position initially to avoid scalping of the grass.
By putting fingers into the grooves in the hubcap
assembly, tighten firmly.
Repeat this step for all wheels, being certain that all
four wheels are in the same height position for an
even cut. Refer to Figure 1 for cutting height
positions.
INSTALLING THE
LOWER HANDLE
AINSTALLING THE
UPPER HANDLE
B
Handle Caps
(731-1805)
Flat Washers
(736-0697)
Lower Handle Plugs
(720-0369)
Handle
Bolt
(710-1718)
Lock Washers
(736-0649)
Wire Clips
(731-2454)
Hex Bolt
(710-1764)
Hex Nuts
(712-0690)
Self Tapping Screws
(710-1350)