ASSEMBLY INSTRUCTIONS

INSTALL AND ADJUST THE D-HANDLE

1.Remove the screws and bottom clamp piece that were installed on the D-handle for shipping.

2.Place D-handle over the shaft housing and onto the bottom clamp (Fig. 1). Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.

3.Start screws with a large Flat-head or T-25 Torx screwdriver. Do not tighten until you make the handle adjustment.

4.If it was pre-installed, loosen the screws on the D-handle just enough to move the D-handle.

5.While holding the unit in the operating position (Fig. 2), move the D-handle to the location that provides you the best grip.

6.Tighten the clamp screws evenly, until the D-handle is secure.

Shaft Grip

(4) Screws

Shaft

Housing

Minimum 6 inches

(15.24 cm)

Bottom Clamp

Fig. 1

Fig. 2

7