Edging Along A Curb
The right, rear wheel of the edger can be lowered into one of five positions to ease the task of edging along a curb.
To adjust the height of curb wheel, proceed as follows:
1.Lower the right, rear wheel by moving the curb height adjustment lever slightly to the left. See Fig.
2.Pivot the right, rear wheel into an applicable position in relation to the height of the curb to be edged along. See Fig.
3.Release the curb height adjustment lever to lock the wheel in position. See Fig.
1
3
2
Figure
5
Operation
And
Adjustment
WARNING
Trenching (Optional)
You can utilize the edger’s optional trenching feature in order to create a wider cutting path for such things as laying wire for landscape lighting. This additional blade is available separately.
WARNING: Disconnect the spark plug wire and ground against the engine before performing the following steps.
WARNING: The edger blade is sharp. Wear leather work gloves to protect your hands when working around the edger blade.
1. Use two wrenches (one wrench to prevent hex bolt |
| |
head from spinning and the other to unthread the |
| |
flange nut) to remove flange nut that secures edger |
| |
blade, leaving the edger blade in place. See Fig. | Figure | |
5. Install an additional edger blade available separately. | ||
|
6.Secure with the flange nut removed earlier. IMPORTANT: Use a torque wrench to tighten the flange nut to between 37
IMPORTANT: Make certain that drive belt is seated correctly on blade spindle and that it is riding smoothly on spindle sheaves and is not pinched between them. Repeat first three steps if belt is pinched.
Disconnect the spark plug wire and ground against the Disconnect the spark plug wire and ground against the engine before performing the following steps.
The edger blade is sharp. Wear leather work gloves to protect your hands when working around the edger blade.
NOTE: Specifications are subject to change without notification or obligation.
Images my not reflect your exact model and are for reference purposes only.
