WARNING! Maximum tire pressure under any circumstances is 30 psi. Equal tire pressure should be maintained at all times. Never exceed the maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
•Approximately 10 psi for the rear tires
•Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer’s recommended or maximum psi. Do not overinflate. Uneven tire pressure could cause the cutting deck to mow unevenly.
Gas and OilThe gasoline tank is located under the hood. Do not overfill.
WARNING! Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes, and other sources of ignition.
Service the engine with gasoline as instructed in the separate Engine Operator/Owner Manual packed with your tractor. Read the instructions carefully.
IMPORTANT: It is important to NOT top off your fuel tank when filling with fuel. Leave an expansion area available inside the fuel tank to allow for the fuel to expand and for proper ventilation. Otherwise the unit may not run properly. Fill the tank in accordance with Figure
Figure
IMPORTANT: Your tractor is shipped with motor oil in the engine. However, you MUST check the oil level before operating. Be careful not to overfill.
Refer to the the separate Engine Operator/Owner Manual packed with your tractor for instructions on checking, changing and servicing the tractor with oil. Read the instructions carefully.
Move the tractor on a firm and level surface, preferably pavement, and proceed as follows:
1.Select the height position of the cutting deck by placing the deck lift lever in the normally desired mowing height setting (any of the six different cutting height notches on the right fender).
2.Check the gauge wheels for contact or excessive clearance with the surface below. The deck gauge wheels should have between ¼” and ½” clearance above the ground.
If the gauge wheels have excessive clearance or contact with the surface, adjust as follows:
a.Raise the deck lift handle to its highest setting.
b.Remove the front and rear gauge wheels by removing the lock nuts and shoulder screws which secure them to the deck. See Fig.
c.Place the deck lift lever in the desired mowing height setting.
d.Reinsert the shoulder screw (with each gauge wheel) into the index hole that leaves approximately ½” between the bottom of the wheel and the pavement.
Figure
Refer to Leveling the Deck in the Maintenance section of this manual for more detailed instructions regarding various deck adjustments.
Section 3 — Assembly & |
| 11 |
| ||
|
|
|