MTX Audio MP52B owner manual MP52 CONFIGURATION GUIDE, Bracket Mounting

MP52 CONFIGURATION GUIDE

BRACKET MOUNTING

ALUMINUM

B-STYLEBRACKET CAP

BRASS

THUMB

SCREW

BRASS

THUMB

SCREW

B-STYLE

CAP

MP52 CONFIGURATION GUIDE

BRACKET MOUNTING

1)Remove the B-Type end caps, brass thumb screws, and aluminum mounting bracket.

2)Hold the bracket up to the desired mounting surface. Being careful to leave enough space for tightening the brass thumb screws and installing the B-Type end caps.

Please Note: Although the speaker can be mounted either horizontally or vertically, the MTM type of design used in the MP52 will produce a more evenly distributed sound through out the listening area if mounted vertically.

3 Use a level or measuring tape to insure that the bracket is square with its surroundings.

4)Mark the locations of the bracket mounting screw holes.

5)Drill pilot holes (if required) into the mounting surface.

6)Pull the speaker wire through the center hole in the bracket.

7)Attach the bracket to the mounting surface. Please Note: The MP52 weighs approximately 9.5 pounds, use only hardware that will support this type of load.

8)Slide the MP52 cabinet into the mounting bracket and secure with the two brass thumb screws.

9)Adjust the MP52 cabinet for the desired angle and tighten the thumb screws.

10)Attach the B-Type end caps by inserting the cap mounting tab into the slot in the back of the speaker baffle. Then snap the cap down onto the brass thumb screws.

7 8